Pre-tested System-on-Chip Design Accelerates PLD Development
Many moderate size Programmable Logic Device (PLD) designs, especially those in control plane applications, consist of a number of interfaces interconnected via an onchip bus to a microprocessor that may be on- or off-chip. Although each interface is often relatively simple, the task of building all the on-chip interconnections and debugging them can be time consuming and frustrating. An increasing number of designers are using development boards with pre-designed processor-based systems to accelerate the development process.
Download this whitepaper to find out more.
Read More
By submitting this form you agree to Lattice Semiconductor Corporation contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. Lattice Semiconductor Corporation web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Connectors, Embedded, Power, Processors, Switches
More resources from Lattice Semiconductor Corporation
CMOS to MIPI D-PHY Interface Bridge Soft IP
MIPI D-PHY is a practical PHY for typical camera and display applications. It is designed to replace traditional parallel bus based on LVCMOS or LV...
LOW COST BOARD LAYOUT TECHNIQUES FOR DESIGNING WITH PLDS IN BGA PACKAGES
Programmable logic devices (PLDs) offer inherent time-to-market and design flexibility advantages over application specific integrated circuits (AS...
Implementing High-Speed DDR3 Memory Controllers in a Mid-Range FPGA
Implementing a highspeed, high-efficiency DDR3 memory controller in a FPGA is a formidable task. Until recently, only a few high-end (read: expensi...
