Implementing High-Speed DDR3 Memory Controllers in a Mid-Range FPGA
Implementing a highspeed, high-efficiency DDR3 memory controller in a FPGA is a formidable task. Until recently, only a few high-end (read: expensive) FPGAs supported the building blocks needed to interface reliably to high speed DDR3 memory devices. However, a new generation of mid-range FPGAs are being developed.
This white paper examines the design challenges, and how one particular FPGA family, the LatticeECP3, can facilitate DDR3 memory controller design.
Download this whitepaper to learn more.
Read More
By submitting this form you agree to Lattice Semiconductor Corporation contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. Lattice Semiconductor Corporation web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Components, Power
More resources from Lattice Semiconductor Corporation
CMOS to MIPI D-PHY Interface Bridge Soft IP
MIPI D-PHY is a practical PHY for typical camera and display applications. It is designed to replace traditional parallel bus based on LVCMOS or LV...
USING LOW COST, NON-VOLATILE PLDS IN SYSTEM APPLICATIONS
System designers are faced with continual pressure to meet their development schedules, and need to implement designs with minimal effort and risk ...
RELIABLE RESET GENERATION FOR TI TMS320C6XXX (“DAVINCI”) PROCESSORS
Every microprocessor or DSP requires a reset generator circuit or IC to perform two functions: (1) start up from a fixed condition after the suppli...
