Resistors
dB or not dB?
True or false: 30 dBm + 30 dBm = 60 dBm? Why does 1% work out to be -40 dB one time but then 0.1 dB or...
From Prototype to Post Deployment: Linux Decision Points
Developing embedded solutions can be a journey. Not all applications start at the same place in the journey...
Parallel & Series Operation
It is much lower cost and causes far fewer problems to use a single power converter correctly rated for...
Maintaining SiC MOSFET Efficiency and Protection without Compromise
The efficiency and size benefits of SiC devices have been enthusiastically embraced by designers of industrial,...
RS-485 Transceiver Tutorial
This in-depth white paper guides you through the choices and weighs key design considerations to help...
RF AND MW CONTROL PRODUCTS IN SILICON
Analog Devices' new RF and microwave (MW) switch and attenuator products implemented in advanced silicon...
System Level Verification and Debug of DDR3/4 Memory Designs
This application note provides an introduction to the DDR memory technology and explains common challenges,...
Sources of Phase Noise and Jitter in Oscillators
The output signal of an oscillator, no matter how good it is, will contain all kinds of unwanted noises...
The wirewound resistor – “the report of my death was an exaggeration”
Like every component, the fabrication technology used in resistor manufacture has changed over time and...
Dual Protocol Transceivers Ease the Design of Industrial Interfaces
This white paper discusses the industry's most commonly used interface standards, RS-232 and RS-485,...
RS-485 Isolator Raises the Bar for Bus Node Designs
This white paper focuses on isolated digital interfaces conforming to RS-485, which continues to be the...
Sign up for Electronic Pro Tech Publish Hub
As a subscriber you will receive alerts and free access to our constantly updated library of white papers, analyst reports, case studies, web seminars and solution reports.